### Additional Manual steps

On systems without Quadlet, some additional steps are required
to get the pipglr container up and running.

### Manual Volume setup

Since several users are utilized inside the container volumes must be
specifically configured to permit access.  This is done using several
*runlabels* as follows:

```bash
$ IMAGE="registry.gitlab.com/qontainers/pipglr:latest"
$ podman container runlabel setupstorage $IMAGE
$ podman container runlabel setupcache $IMAGE
```

Note: These volumes generally do not contain any critical operational data,
they may be re-created anytime to quickly free up host disk-space if
it's running low.  Simply remove them with the command
 `podman volume rm pipglr-storage pipglr-cache`.  Then reuse the `setupstorage`
and `setupcache` *runlabels* as in the above example.

#### Manual Runner Startup

With the runner configuration saved as a Podman secret, and the runner volumes
created, the GitLab runner container may be launched with the following commands:

```bash
$ IMAGE="registry.gitlab.com/qontainers/pipglr:latest"
$ podman container runlabel run $IMAGE
```